Aruba-6200F-48-Access Switch

Access Switch

6200F-48 switch:

To configure the IP address of a syslog server to which the Aruba 6200F-48 switch can direct the logs, you can follow these steps:

• Connect to the switch using a console cable or a Telnet/SSH session.

• Enter the privileged EXEC mode by typing `enable` and providing the password if prompted.

• Enter the global configuration mode by typing `configure terminal`.

• Enter the logging configuration mode by typing `logging`.

• Specify the IP address of the syslog server by typing `host <ip-address>`. You can also specify the UDP port number and the facility level by adding `port <port-number>` and `facility <facility-level>` respectively. For example, `host 192.168.1.100 port 514 facility local7`.

• Exit the logging configuration mode by typing `exit`.

• Save the configuration by typing `write memory`.

You can verify the syslog configuration by typing show logging in the privileged EXEC mode. You can also view the syslog messages on the switch by typing show logging bu